Connect

Guns & Ammo Network


Collapse bottom bar
Subscribe
1911s Guns Gunsmithing Handguns

The 1911: The Importance Of Pin Sizes

by Gus Norcross   |  May 10th, 2013 1

When I was a 19-year-old Cold War tank driver lugging around a World War II-era 1911A1, trigger creep wasn’t an issue in a killin’ gun I would only use in dire circumstances. But times have changed. Now, I really appreciate a crisp trigger on the target range.

When we do a trigger job we attempt to remove excess movement from the fire control components to reduce creep. One thing to watch when tuning triggers is the relationship of the hammer and sear pins to the holes in the frame where they live. Loose pins will result in a mushy trigger rather than the crisp let off we desire.

Begin your inspection by measuring the pins with a micrometer. I’m working on an old Springfield Armory pistol from the 1980s that has been heavily used. Sear and hammer pin sizes are .109″ and .156″ respectively. The sear pin is within the original G.I. tolerance of .110″-.002″. Checking the sear pin hole in the frame with gauge pins reveals a frame hole size of .111″, also within the original G.I. spec (.110″ dia. +.002″). The hammer pin hole will accept a .159″ pin and almost take a .160″ pin, so it’s at the high end of the tolerance (.1575″+ .0015″). That’s about .005″ of movement by the original pins before we have touched the sear and hammer engagement surfaces with a stone.

Fortunately, oversized pins are available to solve our problem. Two sources are Marvel Custom Guns, Inc. in Jarrettsville, Md., and the Cylinder & Slide Shop in Nebraska. The C&S pins are .110″ and .157″ while Marvel offers .112″ and .158″ sizes. Use the pins that best fit your frame. Keep in mind that using oversized pins may require reaming the holes in the hammer and sear. Reamers in the appropriate sizes are available from industrial supply houses such as MSC. A good trigger job should start with custom fitted pins.

  • Jim_Macklin

    A very good tip. Can worn holes be bushed or welded and redrilled? Assuming a 4 way vise and drill press, what are the reference datum for locating the holes correctly? Or is it better to scarp the frame?

back to top